DIRECTIVE 2006/42/EC ANNEX III

ANNEX III
CE marking
The CE conformity marking shall consist of the initials ‘CE’ taking the following form:
If the CE marking is reduced or enlarged the proportions shown in the above drawing must be respected.
The various components of the CE marking must have substantially the same vertical dimension, which may not be less
than 5 mm
. The minimum dimension may be waived for small-scale machinery.
The CE marking must be affixed in the immediate vicinity of the name of the manufacturer or his authorised representative,
using the same technique.
Where the full quality assurance procedure referred to in Article 12(3)(c) and 12(4)(b) has been applied,
the CE marking must be followed by the identification number of the notified body.